Gusty下不能使用fcitx
发表于 : 2007-10-23 17:56
新安装的Gusty,locale为zh_CN.UTF-8,已经安装了fcitx,并通过im-switch设置输入法为fcitx了。但还是不能使用fcitx输入中文。im-switch -l的输出已经是下面这样了:
Your input method setup under zh_CN locale as below.
=======================================================
The configuration "/home/wy/.xinput.d/zh_CN" is defined as a link pointing to
fcitx
This private configuration supersedes the system wide default.
=======================================================
The system wide default is pointed by "/etc/alternatives/xinput-zh_CN" .
xinput-zh_CN - 状态为 manual
链接目前指向 fcitx
scim - 优先级 50
scim-immodule - 优先级 0
scim-pinyin - 优先级 50
fcitx - 优先级 40
目前“最佳”的版本为 scim。
=======================================================
The available input method configuration files are:
default fcitx none scim scim-chewing scim-immodule scim-pinyin th-xim
启动X时其实fcitx已经启动了,并且在登陆过程中有一小段时间也会看到fcitx的主窗口,完全登陆后这一窗口就不见了,但fcitx进程还在。只是ctrl-space时调不出fcitx,只能调出scim。
搜了半天论坛,ms除了卸载scim其它的方法都没用。但卸载scim时会卸载language-support-zh,这个方法不能接受。请问要怎么搞定这一问题啊。
Your input method setup under zh_CN locale as below.
=======================================================
The configuration "/home/wy/.xinput.d/zh_CN" is defined as a link pointing to
fcitx
This private configuration supersedes the system wide default.
=======================================================
The system wide default is pointed by "/etc/alternatives/xinput-zh_CN" .
xinput-zh_CN - 状态为 manual
链接目前指向 fcitx
scim - 优先级 50
scim-immodule - 优先级 0
scim-pinyin - 优先级 50
fcitx - 优先级 40
目前“最佳”的版本为 scim。
=======================================================
The available input method configuration files are:
default fcitx none scim scim-chewing scim-immodule scim-pinyin th-xim
启动X时其实fcitx已经启动了,并且在登陆过程中有一小段时间也会看到fcitx的主窗口,完全登陆后这一窗口就不见了,但fcitx进程还在。只是ctrl-space时调不出fcitx,只能调出scim。
搜了半天论坛,ms除了卸载scim其它的方法都没用。但卸载scim时会卸载language-support-zh,这个方法不能接受。请问要怎么搞定这一问题啊。