UbuntuKylin 14.10 有线网络如何设置呀
发表于 : 2014-11-19 10:34
新的笔记本上装了14.10
在网络链接里面设置了单位的ip,dns后,插上网线,有线链接1 以及以太网 都是灰色的,
不过用ifconfig看了以后,表明我的网卡驱动是装的。
在系统设置》网络》 里面看到 链接 断开, 反复的显示个不停,
请专家们把脉,如何解决我的上网问题,非常感谢
下面是我思路,但是不可行
1、首先用lspci 查看了网卡的型号,
08:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 0c)
可知是Realtek 的 RTL8111/8168/8411 网卡
2、在reltek网站http://www.realtek.com.tw/downloads/downloadsV ... wn=false#2 找到了RTL8111C/RTL8111CP/RTL8111D(L)
RTL8168C/RTL8111DP/RTL8111E
RTL8168E/RTL8111F/RTL8411
RTL8111G/RTL8111GUS/RTL8411B(N)
RTL8118AS
型号的网卡驱动程序 ,我下载了其中64位的驱动,
3、按照驱动里面说明,一步一步的做,
This is the Linux device driver released for RealTek RTL8168B/8111B, RTL8168C/8111C, RTL8168CP/8111CP, RTL8168D/8111D, RTL8168DP/8111DP, and RTL8168E/8111E Gigabit Ethernet controllers with PCI-Express interface.
<Quick install with proper kernel settings>
Unpack the tarball :
# tar vjxf r8168-8.aaa.bb.tar.bz2
Change to the directory:
# cd r8168-8.aaa.bb
If you are running the target kernel, then you should be able to do :
# ./autorun.sh (as root or with sudo)
You can check whether the driver is loaded by using following commands.
# lsmod | grep r8168
# ifconfig -a
If there is a device name, ethX, shown on the monitor, the linux
driver is loaded. Then, you can use the following command to activate
the ethX.
# ifconfig ethX up
,where X=0,1,2,...
RTL8111B/RTL8168B/RTL8111/RTL8168
4、结果还是不能上网,我的系统是linxu64喂。请指教
在网络链接里面设置了单位的ip,dns后,插上网线,有线链接1 以及以太网 都是灰色的,
不过用ifconfig看了以后,表明我的网卡驱动是装的。
在系统设置》网络》 里面看到 链接 断开, 反复的显示个不停,
请专家们把脉,如何解决我的上网问题,非常感谢
下面是我思路,但是不可行
1、首先用lspci 查看了网卡的型号,
08:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 0c)
可知是Realtek 的 RTL8111/8168/8411 网卡
2、在reltek网站http://www.realtek.com.tw/downloads/downloadsV ... wn=false#2 找到了RTL8111C/RTL8111CP/RTL8111D(L)
RTL8168C/RTL8111DP/RTL8111E
RTL8168E/RTL8111F/RTL8411
RTL8111G/RTL8111GUS/RTL8411B(N)
RTL8118AS
型号的网卡驱动程序 ,我下载了其中64位的驱动,
3、按照驱动里面说明,一步一步的做,
This is the Linux device driver released for RealTek RTL8168B/8111B, RTL8168C/8111C, RTL8168CP/8111CP, RTL8168D/8111D, RTL8168DP/8111DP, and RTL8168E/8111E Gigabit Ethernet controllers with PCI-Express interface.
<Quick install with proper kernel settings>
Unpack the tarball :
# tar vjxf r8168-8.aaa.bb.tar.bz2
Change to the directory:
# cd r8168-8.aaa.bb
If you are running the target kernel, then you should be able to do :
# ./autorun.sh (as root or with sudo)
You can check whether the driver is loaded by using following commands.
# lsmod | grep r8168
# ifconfig -a
If there is a device name, ethX, shown on the monitor, the linux
driver is loaded. Then, you can use the following command to activate
the ethX.
# ifconfig ethX up
,where X=0,1,2,...
RTL8111B/RTL8168B/RTL8111/RTL8168
4、结果还是不能上网,我的系统是linxu64喂。请指教